Copy
# Basic Config
esphome:
  name: sonoff_s31
  platform: ESP8266
  board: esp12e

wifi:
  ssid: !secret wifi_ssid
  password: !secret wifi_password

# Remove the following line if you're not using Home Assistsant or your switch will restart every now and again
api:

ota:

# Device Specific Config

logger:
  baud_rate: 0 # (UART logging interferes with cse7766)
  logs:
    sensor: DEBUG # (Overide any global setting, to VERBOSE will spamming the cse7766 sensors)

uart:
  rx_pin: RX
  baud_rate: 4800
  parity: EVEN

binary_sensor:
  - platform: gpio
    pin:
      number: GPIO0
      mode: INPUT_PULLUP
      inverted: True
    name: "Sonoff S31 Button"
    on_press:
      - switch.toggle: relay
  - platform: status
    name: "Sonoff S31 Status"

sensor:
  - platform: wifi_signal
    name: "Sonoff S31 WiFi Signal"
    update_interval: 60s
  - platform: cse7766
    current:
      name: "Sonoff S31 Current"
      accuracy_decimals: 2
      filters:
        - throttle_average: 60s
    voltage:
      name: "Sonoff S31 Voltage"
      accuracy_decimals: 2
      filters:
        - throttle_average: 60s
    power:
      name: "Sonoff S31 Power"
      accuracy_decimals: 2
      id: my_power
      filters:
        - throttle_average: 60s
    energy:
      name: "Sonoff S31 Energy"
      accuracy_decimals: 2
      filters:
        - throttle: 60s
    apparent_power: #(only available with version 2024.3.0 or greater)
      name: "Sonoff S31 Apparent Power"
      filters:
        - throttle_average: 60s
    power_factor: #(only available with version 2024.3.0 or greater)
      name: "Sonoff S31 Power Factor"
      accuracy_decimals: 2
      filters:
        - throttle_average: 60s

  - platform: total_daily_energy #(Optional, not specific to cse7766)
    name: "Sonoff S31 Daily Energy"
    power_id: my_power
    accuracy_decimals: 2

switch:
  - platform: gpio
    name: "Sonoff S31 Relay"
    pin: GPIO12
    id: relay
    restore_mode: ALWAYS_ON

time:
  - platform: sntp #(required for total_daily_energy)
    id: my_time

status_led:
  pin:
    number: GPIO13
    inverted: True